Fujitsu SPARC Enterprise T5140 Product Notes page 125

Issues Fixed in System Firmware 7.1.3.d or Later (Continued)
TABLE A-12
CR ID Description
6654695 The /SYS object has a clear_fault_action
property but setting it to true has no effect. The
command will complete with the message
Set clear_fault_action to true
but nothing will be done.
The /SYS object clear_fault_action property
has been corrected in System Firmware 7.1.3.d or
later.
6654694 Fault Management-generated faults might cause
multiple FRUs to be faulted. When setting
clear_fault_action=true to clear a fault,
only faults on the FRU specified will be cleared, not
all the FRUs that were faulted for the same reason.
6654395 If the LDoms Manager is active on a host machine,
do not reset the service processor while the host
machine is powered on. If the service processor is
reset while the system power is active, the machine
must be power-cycled before the LDoms Manager
can start properly.
6652046 POST error messages for some types of XAUI test
failures can be misleading. The POST error messages
can identify the correct port while reporting the
wrong slot number.
6650585 The output of the showplatform command can be
incorrect, depending upon which commands have
been issued prior to issuing showplatform. This
situation can take several forms. For example:
• After issuing the resetsc command,
showplatform output can display a blank space
as the domain status.
• After poweron, prior to reaching the ok prompt,
showplatform output displays the domain
status as Solaris running.
• After issuing the poweroff command, error
messages that indicate a problem determining host
status can be displayed, such as: Error:
Unable to determine the power
state of the host.
Workaround
Note - Fixed in System Firmware 7.1.3.d or later.
Clear the fault by using the FRU names provided by
the show /SP/faultmgmt command.
Note - Fixed in System Firmware 7.1.3.d or later.
Use the UUID displayed by the show faulty
command to identify all the FRUs that were faulted for
the given UUID, and to clear the fault for each FRU
individually.
Alternatively, use the ALOM CMT compatibility CLI
clearfault command to clear the fault by UUID.
Note - Fixed in System Firmware 7.1.3.d or later.
Note - Fixed in System Firmware 7.1.3.d or later.
XAUI port and slot numbers should match for the
SPARC Enterprise T5140 and T5240 servers
the port number.
Note - Fixed in System Firmware 7.1.3.d or later.
Appendix A
. Use
Fixed Issues 115