Fujitsu SPARC Enterprise T5140 Product Notes page 114

For DC Input Power Models, the Output from the showpower
-v Command May Differ between /SYS/PS0 and /SYS/PS1
(CR 6802433)
This issue is resolved by updating the system firmware to 7.2.2.e or later.
For DC input power models, the INPUT limit value included in the output from the
showpower -v command may differ between /SYS/PS0 and /SYS/PS1. The /SYS/PS1
value is correct.
Example of showpower -v command execution:
sc> showpower -v
----------------------------------------------------------------
Power Supplies:
----------------------------------------------------------------
Supply
----------------------------------------------------------------
/SYS/PS0
/SYS/PS1
----------------------------------------------------------------
Total Power
----------------------------------------------------------------
Supply
----------------------------------------------------------------
/SYS/PS0
/SYS/PS1
sc>
(*) This is incorrect. The /SYS/PS0 value is correct.
Workaround: None. Ignore this issue because it is only a display error.
Sun Explorer May Fail to Collect the ILOM Data (Tx000) (CR
6718841)
This issue is resolved by updating the system firmware to 7.2.2.e or later.
104 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
INPUT
Power
Status
OK 172.8
OK 153.6
326.4
INPUT INPUT
Volt Current
(V) (A)
-48.0 3.60
-48.0 3.20
OUTPUT
Power
(W) (W)
123.8
133.3
INPUT OUTPUT
limit Volt
(A) (V)
37.20 11.9
8.00(*) 11.9
OUTPUT OUTPUT
Current limit
(A) (A)
10.40 99.20
11.20 99.20