Fujitsu SPARC Enterprise T5140 Product Notes page 126

Issues Fixed in System Firmware 7.1.3.d or Later (Continued)
TABLE A-12
CR ID Description
6643241 After resetting the SP, if the Locate button is
depressed, it might take up to 20 seconds before the
Locator LED lights.
Similarly, if the setlocator or showlocator
commands are issued from the ALOM CMT
compatibility CLI within 20 seconds after an SP
reset, the command can fail and produce the
following message:
Error: No locator indicator
6642749 If the host is at the OpenBoot PROM (ok) prompt
when the NUL character is entered, no word
completion will be performed.
If the host has booted the Solaris OS when the NUL
character is entered, the host drops to the minimenu.
For example:
c)ontinue, s)ync, r)eboot, h)alt?
6639312 The /SYS/MB/CMPx components have a
fault_state property and a
clear_fault_action property. These
components should not have these properties since
they are not FRUs, and cannot be faulted or have
their fault state cleared.
However, if a /SYS/MB/CMPx component fails, that
fault_state property of the /SYS/MB target will
be updated correctly.
116 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
Workaround
Note - Fixed in System Firmware 7.1.3.d or later.
Allow up to 20 seconds after an SP reset before
pressing the Locate button to light the Locator LED.
Otherwise, it can take as long as 20 seconds for the
Locator LED to illuminate.
Similarly, if you log into the SP immediately after an
SP reset, wait 20 seconds before issuing the ALOM
CMT compatibility CLI setlocator or
showlocator commands. If those commands are
executed within the first 20 seconds after an SP reset,
the command might not complete successfully,
resulting in the error message. If this situation occurs,
reissuing the command should complete successfully.
Note - Fixed in System Firmware 7.1.3.d or later.
Use Control-\ for command completion when at
the ok prompt.
If the host drops to the minimenu, enter c to resume
normal operation. If you use an application that
performs a particular function when it receives a NUL
character, consult the application's documentation to
determine if there is an alternative method for
performing that function.
Note - Fixed in System Firmware 7.1.3.d or later.
Ignore the fault_state and
clear_fault_action properties of the
/SYS/MB/CMPx targets. Use the fault_state and
clear_fault_action property of /SYS/MB.