Fixed In System Firmware 7.2.8 Or Later - Fujitsu SPARC Enterprise T5140 Product Notes

Fixed in System Firmware 7.2.8 or Later

Issues Fixed in System Firmware 7.2.8 or Later
TABLE A-7
CR ID Description
6919764 In System Firmware 7.2.7.b, after the power-on of a
system mounted with the Fujitsu 4Gbps Fibre
Channel card, the message "F20CARD prom is
unreadable or corrupted" may appear in the
ILOM event log and the Service Required LED may
turn on.
Solaris OS completes the startup normally, and the
fibre channel card is normally recognized on Solaris
OS.
For details, see
Fujitsu 4Gbps Fibre Channel Card, the Service
Required LED May Turn On after the System Power-
on (CR 6919764)" on page
On a System Mounted with the Fujitsu 4Gbps Fibre Channel
Card, the Service Required LED May Turn On after the
System Power-on
(CR 6919764)
This issue is resolved by updating the system firmware to 7.2.8 or later.
In System Firmware 7.2.7.b, after the power-on of a system mounted with the Fujitsu 4Gbps
Fibre Channel card, the message "F20CARD prom is unreadable or corrupted"
may appear in the ILOM event log and the Service Required LED may turn on.
Solaris OS completes the startup normally, and the fibre channel card is normally recognized
on Solaris OS.
The show faulty command output example:
-> show faulty
Target
--------------------+------------------------+--------------------------------
/SP/faultmgmt/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
->
92 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
"On a System Mounted with the
92.
| Property
| fru
| timestamp
|
| sp_detected_fault
|
Workaround
Note - Fixed in System Firmware 7.2.8 or later.
After you insert the power cord, or after the ILOM
reset complete, wait for about 180 seconds and then
power on the system.
| Value
| /SYS
| Apr 06 09:41:17
|
| /SYS/MB/RISER0/PCIE3/F20CARD
| prom is unreadable or corrupted