Fujitsu SPARC Enterprise T5140 Product Notes page 41

Recovery procedure: Replace the XAUI card by using the following procedure:
[Using ILOM command mode]
1. Execute stop /SYS.
2. Delete the XAUI and GBE components from the asr-db blacklist.
Execution example:
-> set /SYS/MB/RISER1/XAUI1 component_state=enabled
-> set /SYS/MB/GBE component_state=enabled
3. Disconnect the power cord from the AC outlet.
4. Replace the XAUI card.
5. Connect the power cord to the AC power source.
[Using ALOM CMT compatible shell]
1. Execute the poweroff command.
2. Delete the XAUI and GBE components from the asr-db blacklist.
Execution example:
sc> enablecomponent /SYS/MB/RISER1/XAUI1
sc> enablecomponent /SYS/MB/GBE
Alternatively, execute the clearasrdb command.
3. Disconnect the power cord from the AC outlet.
4. Replace the XAUI card.
5. Connect the power cord to the AC power source.
XAUI Card Disables an Onboard Network Port
Installing a 10GbE XFP XAUI Adapter Card (XAUI card) in slot 0 disables on-board
network port 1 (NET1)(*1). Installing the XAUI card in slot 1 disables on-board network
port 0 (NET0)(*2).
Chapter 3 Known Issues 31