Fujitsu SPARC Enterprise T5140 Product Notes page 48

Firmware and General Software Issues (Continued)
TABLE 3-4
CR ID Description
6932448 Messages referring to hot insertions/removals of
devices including a nonexistent device are displayed
at power on if the system has had a system
initialization, firmware upgrade, or system
component change.
Message example:
Chassis | major: Hot insertion of
/SYS/MB/CMP0/P0
or
SC Alert: [ID 639621 daemon.error] SC
unretrieved msg: [Chassis | major: Hot
insertion of /SYS/MB/CMP0/P3]
Chassis | major: Hot removal of HDD3
or
SC Alert: [ID 677427 daemon.error] SC
unretrieved msg: [Chassis | major: Hot
removal of HDD3]
6913388 The ILOM event log may not be in the Solaris OS
system log output (/var/adm/messages).
ILOM login event example:
Nov 7 14:13:03 xxxxxx SC Alert: [ID
178418 daemon.notice] Audit | minor:
admin : Open Session :
object = /session/type : value =
shell : success
Nov 7 14:13:04 xxxxxx SC Alert: [ID
434268 daemon.notice] Audit | minor:
admin : Close Session :
object = /session/type : value =
shell : success
6856391 When the host is powered off, the value of ambient
temperature sensor (MB/T_AMB) is not correctly
displayed in the output of showenvironment
command.
38 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
Workaround
None.
Those messages are displayed when the ILOM
firmware recognizes the system configuration at
system initialization, firmware upgrade, or system
component change. You can ignore the messages.
None.
Perform the ILOM reset operation. If not recovered,
shut down the system and then remove and insert the
power cord.
ILOM reset operation example:
Log in to ILOM and execute the following command.
[Using ILOM command mode]
-> reset /SP
Are you sure you want to reset /SP
(y/n)? y
[Using ALOM CMT compatible shell]
sc> resetsc
Are you sure you want to reset the
SC [y/n]? y
None.
This issue can be ignored.