Fujitsu SPARC Enterprise T5140 Product Notes page 97

...
MB
...
Slot Number of Link Card Connected to PCI Box Is Falsely
Displayed (CR 6942238)
This issue is resolved by updating the system firmware to 7.2.10 or later.
When you mount a link card connected to PCI box and start the system, the slot number is
falsely displayed in the LEDs and FRU Status of the prtdiag -v command output.
Shown below is an event example in time of failure.
Configuration:
PCIE#0: void
PCIE#1: void
PCIE#2: void
PCIE#3: void
PCIE#4: void
PCIE#5: Link Card
The ILOM CLI interface output example:
/SYS/MB/RISER0/PCIE3/LINK
Properties:
type = Link Card
fru_description = Copper Link Card
fru_manufacturer = Celestica
fru_version = 02_51
fru_part_number = 5017041
fru_serial_number = XP00DD
fault_state = OK
connection = none
clear_fault_action = (none)
LEDs and FRU Status in the prtdiag -v command output:
# prtdiag -v
...
LEDs:
------------------------------------------------------
Location
FIBRE fibre-channel
/pci@500/pci@0/pci@9/fibre-channel
LED State
Appendix A Fixed Issues 87