Integrated Lights Out Manager (Ilom) 3.0 Web Interface Procedures Guide - Fujitsu SPARC Enterprise T5140 Product Notes

Integrated Lights Out Manager (ILOM) 3.0
Web Interface Procedures Guide
Notes on "Enable and Disable Components" (CR
6624705)
In the procedure to "Enable and Disable Components" in "Viewing Component Information
and Managing System Components" on page 68, even when you select either Enable or
Disable from the Actions drop-down list, a log that indicates the execution from the ILOM
CLI interface is output.
Fault | critical: SP detected fault at time Wed Jul 18 09:37:15
2007. /SYS/MB/GBE1 Disabled by CLI action.
Erroneous Description about Collecting SP Data
The following description in the section "Collect SP Data to Diagnose System Problems" on
page 79 includes incorrect information.
3. Select the desired Data Set: Normal, Full, or Custom.
Normal – Specifies that ILOM, operating system, and hardware information is collected.
■
Full – Specifies that all data is to be collected. Selecting Full might reset the system.
■
Custom – Allows you to choose one or more of the following data sets:
■
■
■
■
■
On the SPARC Enterprise T-series servers, when you specified the full option, the host in
execution will not be reset. While the host is executing, you can specify the full option.
Notes on Downloading System Firmware
For the information on how to get the patch releases, contact your sales representative.
60 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
ILOM Data
Hardware Data
Basic OS Data
Diagnostic Data