Fujitsu SPARC Enterprise T5140 Product Notes page 113

Issues Fixed in System Firmware 7.2.2.e or Later (Continued)
TABLE A-9
CR ID Description
6718841 Sun Explorer may fail to collect the ILOM data
(Tx000). If failed, it may take more than 30 minutes
to return an error.
6701972 Even when the "SSH Server" setting is changed from
"Disabled" to "Enabled" on the "SSH Server" tab on
the ILOM Web interface, "Disabled" is still
displayed.
The "SSH Server" setting is valid.
6694693 ILOM allows only two privileges: Administrator and
Operator. Therefore, the following text about the
ALOM CMT userperm command in the manual is
inappropriate.
If one of [c], [u], [a], and [r] is set, Administrator
authority will be in effect. If nothing is specified,
Operator authority will be in effect.
<Integrated Lights Out Manager 2.0 Supplement>
userperm [username] [c][u][a][r]
6656116 If the DIMM module fails, the MCU will be
disconnected, and an error message might be output
to the console.
For an example of the message, see
Disconnected in DIMM Module Failure (CR
6656116)" on page
6586305 Using the SP setdate command (ALOM
compatibility shell) after having configured non-
default logical domains can cause the date on non-
default domains to change.
6579390 After disabling a DIMM, the OpenBoot PROM
banner does not show a decrease in the amount of
memory.
"MCU Might Be
106.
Workaround
Note - Fixed in System Firmware 7.2.2.e or later.
You can collect the ILOM data (Tx000) in another
way.
For details, see "Sun Explorer May Fail to Collect the
ILOM Data (Tx000) (CR 6718841)" on page
Note - Fixed in System Firmware 7.2.2.e or later.
Refresh the page information by clicking the "Refresh"
button on the ILOM Web interface.
Note - Fixed in System Firmware 7.2.2.e or later.
None.
Note - Fixed in System Firmware 7.2.2.e or later.
Identify and replace the faulty DIMM module.
Note - Fixed in System Firmware 7.2.2.e or later.
Use the setdate command to configure the date on
the SP before configuring and saving logical domain
configurations.
If you use setdate after non-default logical domain
configurations have been saved, each non-default
domain must be booted to Solaris OS and the date
corrected. (See date(1) or ntpdate(1M).)
Note - Fixed in System Firmware 7.2.2.e or later.
If you manually disable any CPU or memory resource
with the ASR commands while the host is powered on,
you must power cycle the host to complete the
disabling of the resource.
After the power cycle, the resource will be disabled,
and the proper information will be displayed in the
banner.
Appendix A
104.
Fixed Issues 103