Replacing The Char Grill Piezo Battery - Beech ovens REC Series Installation And Operation Manual

Beech Ovens
RND-REC-RGO Manual (R1)
Continue to press the main valve for twenty (20) seconds. (This is to allow the
thermocouple enough time to sense a flame and open the main burner's gas supply.)
Release the main valve. (The pilot flame should now stay alight.)
To choose between High and Low Flame, slightly depress the main valve and turn to
the required flame.
For the three (3) and four (4) burner Char Grills, repeat for both pilots.
To turn off, depress the main valve slightly and turn to
(The Char Grill can be safely left in the Pilot position when not in use, though it is
recommended to turn to the

Replacing the Char Grill Piezo Battery

If the Piezo does not spark, it is possible that the battery has expired. To replace the
battery follow the instructions below.
1. Unscrew the Piezo button.
2. Replace the battery.
(Be sure to insert the new
battery with the poles in the
correct direction)
3. Replace the Piezo button.
(Do not over tighten)
If the Piezo still does not spark – having checked that the battery is OK and fitted
correctly – check that the cable from the Piezo to the pilot is connected and in good
repair. For further
technical@beechovens.com
Page 95
●
(OFF) position when finishing for the day.)
assistance contact
Confidential and Proprietary
●
(OFF) position.
Beech Ovens service
28/07/2011 (C)
department