Beech ovens REC Series Installation And Operation Manual page 133

Beech Ovens
RND-REC-RGO Manual (R1)
14. Fault/Reset light comes on.
15. Gas burner not turning off.
16. No lights on Gas Control cabinet
(Digital Temp Controller/ Burner ON).
17. Flame leaking out from blow back
chute.
18. Excessive Gas consumption.
19. Cracked upper refractory.
20. Burner flame popping loud on
startup
14.1 Gas supply problems. (For LPG, is tank near empty)
14.2 Ventilation problem, flame being drawn under the oven floor.
14.3 Tri-electrode dirty, contaminated, loose etc.
14.4 Leads to Tri-electrode faulty/fallen off.
14.5 Faulty Flame pack.
14.6 Faulty Gas Combination valve.
14.6 Air in gas lines. (refer to Connection procedures)
15.1 Thermocouple faulty / fallen out.
15.2 Faulty Digital Temperature controller
15.3 Check „SV‟ setting on Digital Temperature Controller.
15.4 Faulty Flame pack.
16.1 Power supply problems.
16.2 Circuit breaker inside cabinet tripped.
16.3 Bulbs faulty - blown
17.1 Incorrect System Balancing
17.2. Ventilation problem, flame being drawn under the oven floor.
18.1 Incorrect System Damper calibration. Oven loosing heat.
18.2 Incorrect door position.
18.3 Incorrect flame calibration.
18.4 Incorrect gas pressure adjustment.
18.5 Leakage in supply line.
18.6. Ventilation problem, flame being drawn under the oven floor.
18.7 Incorrect jet /orifice
19.1 Insufficient Preheating of the oven.
20.1 Tri-electrode misaligned to flame
20.2 Build up of charcoal or debris on burner
Page 132
14.1.1 Check gas supply (Contact service technician).
14.2.1 Refer to System Balancing or
14.3.1 Refer to Tri-electrode and Burner Maintenance.
14.4.1 Refer to Connection Procedures.
14.5.1 Replace Flame pack.
14.6.1 Replace Gas Combination valve.
14.7.1 Refer to Connection Procedures.
15.1.1 Refer to Thermocouple. Replace if faulty.
15.2.1 Refer to Digital Temperature Controller.
15.3.1 Refer to Digital Temperature Controller.
15.4.1 Replace Flame pack.
16.1.1 Check power supply (Contact electrician).
16.2.1 Check power supply. Refer to Gas Systems Overview.
16.3.1 Replace bulbs
17.1.1 Refer to System Balancing.
17.2.1 Refer to Oven Ventilation.
18.1.1 Refer to System Damper Calibration.
18.2.1 Refer to Plug Door Placement.
18.3.1 Refer to Flame Calibration.
18.4.1 Refer to Flame Calibration.
18.5.1 Turn off main gas supply at Manual Gas Isolation Valve
in Gas Control Cabinet. Contact service technician.
18.6.1 Refer to System Balancing or
18.7.1 Contact service technician
19.1.1 Refer to Preheating with Gas / Wood.
20.1.1 Refer to Tri-electrode and Burner Maintenance.
20.2.1 Inspect and clean burner
28/07/2011 (C)
Confidential and Proprietary
www.beechovens.com
www.beechovens.com