Gas Control Cabinet Functions; Main Control Switch; Burner On Indicator Light - Beech ovens REC Series Installation And Operation Manual

Beech Ovens
RND-REC-RGO Manual (R1)

Gas Control Cabinet Functions

Main Control Switch

The Main Control Switch has three positions:
OFF
Both temperature controller & burner are off in
this position.
CONTROL
The temperature controller only is energized.
In this position the temperature controller will
read the current oven temperature (PV) and
the set point temperature (SV). The current
oven temperature (PV) is monitored at the
stone hearth (floor) level. The actual oven
temperature will be higher than indicated. This
is useful if firing on timber to easily see the
cooking temperature. This is a read out only and has no control over the oven
temperature with the control switch in this position.
ON
In this position the oven will start automatically, cycling the gas system to maintain the
preset temperature or set point temperature (SV) of the oven.
The operation of the gas flame will cycle automatically from Low Flame to High Flame
or Off as required to maintain the set point temperature.
See Digital Temperature Controller description below for more details.

Burner On Indicator Light

This light is lit when the ON position is selected on the main control switch and a flame
is preset inside the oven.
The main control switch should always be set to OFF when any service work or
inspections occur. Disconnect power from the wall socket. All service work
should be carried out by a qualified and authorized technician.
Page 90
Confidential and Proprietary
28/07/2011 (C)