Fault/ Reset Button; Digital Temperature Controller - Beech ovens REC Series Installation And Operation Manual

Beech Ovens
RND-REC-RGO Manual (R1)

Fault/ Reset button

In the event of the burner failing to light, the Fault/ Reset button will light and the burner
will go into „lock-out mode‟. In this mode, the oven is 100% safe; no gas can flow.
To restart the burner from „lock-out mode‟ (white light on) press the white light „reset‟
button. If the burner fails to light after three attempts, turn the control switch to OFF and
refer to the troubleshooting section of this manual or call in a service professional.

Digital Temperature Controller

The Digital Temperature controller has two
(2) main functions. To display the current
oven temperature (PV- Present Value) and
an adjustable setting to enable the operator
to determine the desired oven operating
temperature (SV - Set point value).
To change the set point (SV) temperature
up or down;
 Press SET
 Press ◄R/S to move the degree of
change. (i.e. to change tens or
hundreds)
 Press the ▲ (up) or ▼ (down) arrows until desired temperature is selected
 Press SET to enter the information
See the following section for the different temperature control procedures.
Page 91
Confidential and Proprietary
28/07/2011 (C)