System Connection; Contractors Responsibility; Venting The Oven - Beech ovens REC Series Installation And Operation Manual

Beech Ovens
RND-REC-RGO Manual (R1)

System Connection

The Gas control cabinet is delivered pre-set from the factory, though should be re-
checked upon connection. Gas pressure should be checked as per the Flame
Calibration section in this manual. The following section explains the installation and
connection procedures for the Gas and Electrical systems.

Contractors Responsibility

Fitting the Thermocouple, Tri-Electrode leads and Gas line connection are all part of the
connection procedure. Always check for correct set-up for local gas supply. The system
will require earthed mains electricity 220-240V at 50Hz and a gas supply line for final
connection. Please ensure that the gas supply line is sufficiently sized to handle the gas
load.
Refer to the Gas Data plate located inside the Gas control cabinet.
All work required for installation must be carried out by approved persons and
comply with all local codes and regulations in force at time of installation.

Venting the Oven

With all ovens using Gas, to sustain a flame,
the oven utilizes primary and secondary air
(oxygen) from below the oven floor. An open
vent must always be made available to the
underside of the oven for this reason.
Ventilation must come from the same
room as the door of the oven. This is
usually incorporated
inspection or access panel at the front of the
oven, or at a convenient location as to allow
easy access to the underside of the oven.
The size of the vent should be a minimum
of 600mm x 600mm.
Typical access panel with
louvers to allow fresh air
(oxygen) to feed the burner
flame
For more information on this matter see the Ventilation Requirement section in this
manual.
Page 52
into a removable
28/07/2011 (C)
Confidential and Proprietary