Assembly - Beech ovens REC Series Installation And Operation Manual

Beech Ovens
RND-REC-RGO Manual (R1)

Assembly

The procedure mentioned below uses an "A-Frame" lifting method for assembling the
oven. Other lifting methods may be used e.g. a fork truck or crane, however the
following principals still apply.
Assemble lifting frame in kitchen where space permits.
(The assembled oven must be able to be moved
within the kitchen area without obstruction later on the
trolley.)
Lift the oven top to such a height to leave a
clear space underneath of minimum 1150mm to
enable the base of the oven to fit under oven
top.
(Lift the base of the oven to a horizontal position
and fit legs if previously removed.)
Page 16
Utilizing lifting point 3 on previous diagram, lift the
top free of the pallet and place on the ground, whilst
moving the base into position.
Move base under elevated top section using a lifting
frame or a stack of narrow pallets, being careful not to
damage any equipment under the oven; e.g.
burners, sensors, etc.
You may now remove the protective plywood from the
top of the base.
28/07/2011 (C)
Confidential and Proprietary