Carriage And Carriage Shaft - OKIDATA Pacemark 3410 Service Manual

Page: 56
Service Guide PM3410
Chapter 3 Maintenance & Disassembly

3.2.22 Carriage and Carriage Shaft

(3.2.21)
1. Remove the head cable assembly
2. Loosen the slider mounting screw (1) and push it towards the back of the printer.
3. Remove the belt clamp mounting screw (2) and detach the belt clamp (3).
4. Loosen the screw (4) and detach the left printhead gap adjusting collar (5).
NOTE:
The protrusions on the collar face the outside of the printer.
5. Remove the screw and detach the blue printhead gap adjusting lever (not shown).
6. Loosen the screw (6) and detach the right printhead gap adjusting collar (7).
7. Pull the two rubber carriage bumpers (8) from the carriage shaft (9).
8. Slide the carriage shaft to the right and remove the shaft and the carriage assembly (10).
NOTES:
Installation
Be sure that the larger extension at the end of the carriage shaft is positioned to the right.
Perform the printhead gap adjustment after installing this assembly. Refer to Section 3.3
P/N 53340501 Carriage: (Assembly) RSPL B.2.05
P/N 50706701 Collar: Eccentric (with Screw) RSPL B.2.06
P/N 51112101 Shaft: Carriage RSPL B.2.06
P/N 53063801 Bracket: Printhead Gap Indicator RSPL B.2.06
P/N 53478401 Lever: Adjust RSPL B.2.06