Carriage And Carriage Shaft - OKIDATA ML395C Service Manual

Page: 53
Service Guide ML395/395C
Chapter 3 Maintenance & Disassembly

3.2.19 Carriage and Carriage Shaft

1. Loosen the screw (1) and slide it towards the back of the printer.
2. Loosen the mounting screw (2) and detach the left eccentric collar (3).
NOTE: The protrusions on the eccentric collars face the outside of the printer.
3. Remove the screw and detach the blue printhead gap adjusting lever. (Not shown)
4. Loosen the screw (4) and detach the right eccentric collar (5).
5. Remove the two rubber carriage bumpers (6).
6. Slide the carriage shaft (7) to the right and remove the carriage (8).
7. Continue sliding the carriage shaft to the right then remove the carriage shaft.
NOTE: When installing, be sure that the larger extension at the end of the carriage shaft is positioned at
the right side of the printer.
P/N Spacer B.2.04 , 05
P/N Spacer: Round B.2.04 , 05
P/N 50057601 Carriage Assembly (Black) B.2.04 , 07
P/N 50069401 Carriage Assembly (Color) B.2.05 , 10
P/N 50703701 Collar: Eccentric Carriage Rail RSPL B.2.07 , 10
P/N 51110301 Shaft: Carriage RSPL B.2.07 , 10
P/N 53478401 Lever: Adjust (Printhead Gap) RSPL B.2.07 , 10