OKIDATA Pacemark 3410 Service Manual page 123

Serial I/F
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Auto Feed XT (Epson /
IBM)
Parity
Serial Data 7 or 8 Bits
Protocol
Diagnostic Test
Busy Line
Baud Rate
DSR Signal
DTR Signal
Busy Time
Invalid Valid
None Odd Even
8 Bits 7 Bits
Ready/Busy
X-ON/X-OFF
No Yes
SSD- SSD+ DTR
RTS
19200 9600 4800
2400 1200 600 300
bps
Valid Invalid
Ready on Power Up
200 mS 1 sec
Epson Emulation Some
interface cables are
wired so that the XT
signal always causes
an automatic line feed.
The Invalid setting
eliminates this. Use
the Valid setting if the
system uses the XT
signal for automatic line
feed.
Set to Yes to run the
serial interface
diagnostic test. To
restore to full operation
power OFF the printer.
Press and hold PRINT
QUALITY and PITCH
and power ON the
printer. This will place
the printer in Menu
Mode. Then change
this setting to NO for
normal operation.
Ready on Select