Printhead (With Preliminary Items) - OKIDATA Pacemark 3410 Service Manual

Page: 35
Service Guide PM3410
Chapter 3 Maintenance & Disassembly

3.2.01 Printhead (with Preliminary Items)

WARNING:
The printhead will be HOT immediately after printing.
1. Open the printer access cover (1).
2. Remove the ribbon cartridge (2).
3. Set the head gap adjusting lever (3) to the range 9 position.
4. Lift and remove the ribbon guide (4) from the two posts.
5. Remove the two printhead mounting screws (5).
6. Disconnect the printhead (6) from the connector by lifting.
NOTES:
Installation
Push the printhead towards the platen (in the direction of Arrow A).
Perform the printhead gap adjustment. Refer to Section 3.3
P/N 50215701 Cover: Access RSPL B.2.02
P/N 50090301 Printhead: Assembly RSPL B.2.03
P/N 52105801 Ribbon Cartridge Consumable B.2.03 , B.2.12
P/N 56609701 Cord: AC (120V) RSPL B.2.03
P/N 56624101 Cord: AC (220V) (ML) Right Angle Option B.2.03
P/N 53062601 Guide: Ribbon Assembly RSPL B.2.05