OKIDATA Pacemark 3410 Service Manual page 121

0.15 mm Right
0.05 mm Left
0.25 mm Left
Group
Set-Up (continued
Paper Out Override
Print Registration
0.10 mm Right
0.10 mm Left
Adjusts the vertical
registration in graphics.
The best setting may
vary from one software
package to another.
Item
Operator Panel
Function
Reset Inhibit
No Yes
0.25 mm Right
0.05 mm Right
0.15 mm Left
Setting
Full Operation Limited
Operation
No Yes
A sensor stops printing
about 1 inch from the
bottom of a single
page. Changing this
setting to YES allows
printing to occur closer
to the bottom edge of
the paper.
0.20 mm Right
0.00 mm
0.20 mm Left
Notes
Changing this setting to
Limited Operation
deactivates the menu
mode and these control
panel buttons: TOP
OF FORM MICRO
FEED UP/DOWN
PRINT QUALITY and
PITCH. This is used in
situations where
several people are
using the printer. To
restore to full operation
power OFF the printer.
Press and hold PRINT
QUALITY and PITCH
while powering ON the
printer. The printer will
be in Menu Mode.
Change this setting to
FULL OPERATION.
Changing this to Yes
prevents a reset signal
from the computer from
resetting the printer to
its defaults.