Font Sample Test - OKIDATA Pacemark 3410 Service Manual

Page: 114
Service Guide PM3410
Chapter 4 Failure & Repair Analysis

4.8.02 Font Sample Test

NOTE:
This test will not run unless continuous feed paper is installed in the printer .
General Information
The Font Sample Test print samples of fonts at various character pitches.
This test will not run unless continuous feed paper is installed in the printer.
The header contains information which can be helpful when servicing the printer.
Printer Model
Character Set
Firmware Part Number (Current part numbers are available through Okilink II)
Emulation
Firmware / Character Generator Revision Level
Procedure
To perform the Font Sample Test, follow this procedure.
1. Verify that continuous feed paper is installed.
2. Verify that the ribbon is correctly installed.
3. Verify that the width of the installed paper matches the paper width menu setting.
4. Power OFF the printer.
5. Press LINE FEED as you power ON the printer.
6. The test will print.
7. To stop the test (at any time), press SELECT.
8. When the two page test is complete, the SELECT lamp will turn OFF.
9. Press SELECT to place the printer ON-LINE.
Font Test Sample - Part 1.....
Font Test Sample - Part 2.....
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)