Shaft Link - OKIDATA OKIPAGE 8c Service Manual

3.3.35 Shaft Link

1. Remove the eraser bracket assy. (See 3.3.34)
2. Remove the gear one-way (Z30). (See 3.3.14.)
3. Remove the E-ring (3) by sliding the sensor assy T (KCM) (1) and bracket sensor T (KCM) (2)
together in the arrow (A) direction.
4. Release the engagement between the lever Up/Dn and boss A of the lever link (R) (5) by sliding the
spring support (R) (4), lever link (R) (5) and the bearing (6) together in the arrow (B) direction. (Keep
on sliding until the lever link (R) (5) reaches the end of D-cut part of the shaft link (7).)
5. Draw out the entire shaft link (7) by pressing it in the arrow (C) direction and turning its left side under
the contact (BL L) assy.
6. Detach the sensor assy T (KCM) (1), bracket sensor T (KCM) (2), spring support (R) (4), lever link
(R) (5) and the bearing (6) from the shaft link (7).
7. Remove 2 E-rings (8) then remove the spring support (L) (9) and lever link (L) (10).
[Notice for mounting]
z
Engagement between the lever Up/Dn and boss A of the lever link (R) (5): Mount the spring support
(L (9) and lever link (L (10) in the predetermined positions, then clamp the boss A of lever link (R) (5)
with the lever Up/Dn by adding rotating power on the spring support (L) (9) by rotating the shaft link
(7).
z
Mounting of the spring support (R) (4): Clamp the spring support (R) (4) at the predetermined
positions in the lever link (R) (5) and the contact BKT (R).
Service Guide - OKIPAGE 8c
Chapter 3 Disassembly
Page: 62