OKIDATA Pacemark 3410 Service Manual page 122

Group
Parallel I/F
Print Suppress
Effective
Auto LF
Auto CR (IBM only)
CSF Bin Select
SI Select Pitch (10 cpi -
IBM ONLY)
SI Select Pitch (12 cpi -
IBM ONLY)
Time Out Print
(Epson/IBM)
Auto Select
Sensor Disable
Item
I-Prime
Pin 18
Yes No
No Yes
No Yes
Bin 1 Bin 2
17.1 15 cpi
20 12 cpi
Valid Invalid
No Yes
No Yes
Setting
Buffer Print Line End
Invalid
+5 0 V
Determines whether
the DC3 code causes
the printer to ignore
data until a DC1 code
is received.
Only available when the
dual bin cut sheet
feeder (CSF 3002) is
installed. Determines
which bin is active.
Sets the pitch of
condensed mode from
10 cpi using the SI
code.
Sets the pitch of
condensed mode from
12 cpi using the SI
code.
When set to Valid
contents of the buffer
will print when
additional data is not
received for a
predetermined amount
of time.
Notes
Buffer Print = I-Prime
makes printer print
contents of buffer. Line
End = I-Prime makes
printer print to the end
of the current line.
Invalid = I-Prime the
signal is ignored.
Determines whether
voltage is supplied to
pin 18.