Kontron CP308 User Manual page 34

Introduction
Table 1-1: 4HP CP308 Main Specifications (Continued)
CP308
USB
Serial
Keyboard and Mouse
I/O Expansion
Interfaces
Mass Storage
Front Panel Connectors
Onboard Connectors
Page 1 - 12
Eight USB ports supporting UHCI (USB 1.1) and EHCI (USB 2.0):
•
Two USB 2.0 ports on the front I/O
•
Two USB 2.0 ports on the rear I/O interface
•
Three USB 2.0 interfaces for the onboard high-speed I/O extension con-
nector
•
One onboard USB 2.0 port for the USB 2.0 NAND Flash module
Two 16C550-compatible UARTs:
•
COM1 available on the I/O expansion module or on rear I/O
•
COM2 available on rear I/O only
USB keyboard and mouse support
I/O expansion to 8HP board version:
•
2x SATA
•
Graphics ports either:
•
PCIe x16 or
•
SDVO (Serial Digital Video Output), HDMI (High-Definition Multime-
dia Interface), and DP (DisplayPort)
•
3x USB2.0
•
4 x1 PCIe or 1 x4 PCIe
•
HDA
•
PS/2
•
SPI
•
COM
•
Monitor and control signals
Onboard USB 2.0 NAND Flash:
•
Onboard USB 2.0 NAND Flash module supported on J14
SATA: Integrated Serial ATA Host Controllers
•
Provide independent DMA operation on four ports:
•
Two onboard SATA interfaces
•
Two SATA interfaces switchable to rear I/O or to the 8HP expansion
module
•
Data transfer rates up to 3 Gbit/s
•
High-performance RAID 0/1 functionality on all SATA ports
•
VGA: 15-pin D-Sub connector
•
USB: two 4-pin, type A connectors
•
Ethernet: dual RJ-45 connector
•
Two 7-pin, L-form standard SATA II connectors
•
One USB 2.0 NAND Flash connector
•
High-speed graphics extension connector
•
High-speed I/O extension connector
•
SPI extension connector
•
Two 204-pin DDR3 SODIMM sockets
•
CompactPCI Connectors J1 and J2
SPECIFICATIONS
ID 1027-4487, Rev. 3.0
CP308