CP308
2.2.6
USB 2.0 NAND Flash Module
The CP308 supports one optional USB 2.0 NAND Flash module qualified by Kontron. The USB
2.0 NAND Flash module is connected to the onboard connector J14. If an 8HP expansion mod-
ule is used with the CP308, it is not possible to install a USB 2.0 NAND Flash module on the
4HP CP308. Refer to Appendix A, CP308-HDD Module, for connecting a USB 2.0 NAND Flash
module to the 8HP CP308.
The USB 2.0 NAND Flash module is a USB 2.0-based NAND Flash drive with a built-in full
hard-disk emulation and a high data transfer rate. It is optimized for embedded systems pro-
viding high performance, reliability and security.
Note ...
Only qualified USB 2.0 NAND Flash modules from Kontron are authorized for
use with the CP308. Failure to comply with the above will void the warranty and
may result in damage to the board or the system.
2.2.7
8HP Expansion Modules
The CP308 supports the CP308-HDD and the CP308-MEDIA as optional 8HP expansion mod-
ules via the 120-pin high-speed graphics extension connector J15, the 120-pin high-speed I/O
extension connector J12, and the 10-pin SPI connector J9.
For further information regarding the CP308-HDD module, refer to Appendix A. For further in-
formation regarding the CP308-MEDIA module, refer to Appendix B.
2.2.8
Integrated Trusted Platform Module (iTPM)
The Integrated Trusted Platform Module (iTPM) included in the chipset consists of firmware,
Intel® Management Engine resources and dedicated hardware within the ICH9M-SFF and the
GS45 GMCH. The iTPM supports all requirements of the TPM Specification Version 1.2, Level
2, Revision 103, as published by the Trusted Computing Group.
ID 1027-4487, Rev. 3.0
Functional Description
Page 2 - 9