Kontron CP308 User Manual page 35

CP308
Table 1-1: 4HP CP308 Main Specifications (Continued)
CP308
LEDs
Watchdog
Thermal Management
System Management
Controller
uEFI BIOS
Operating Systems
ID 1027-4487, Rev. 3.0
Watchdog and Overtemperature Status LEDs:
•
WD (green)
•
TH (green)
System Management Controller LED:
•
SMC LED (red/green/red+green): System Management Controller Status
General Purpose LEDs:
•
LED 0..3 (red/green/red+green): General Purpose / POST Code
Integral Ethernet LEDs:
•
ACT (green)
•
SPEED (green/orange)
Software-configurable Watchdog generates an IRQ or a hardware reset.
CPU overtemperature protection is provided by:
•
Internal processor temperature control unit
•
CPU shut down via hardware monitor
•
Standard heat sink
System Management Control with the NXP LPC2136 32-bit microcontroller for
monitor and control of:
•
Several system power voltages
•
One fan speed input
•
One fan PWM output
•
Processor, memory, and board temperature
•
Further CompactPCI boards installed in the system via the IPMB bus on
the J1 CompactPCI Connector
AMI Aptio®, AMI's next-generation BIOS firmware based on the uEFI Speci-
fication and the Intel Platform Innovation Framework for EFI.
•
LAN boot capability for diskless systems (standard PXE)
•
Redundant image; automatic fail-safe recovery in case of a damaged
image
•
Non-volatile storage of setting in the SPI Flash (battery only required
for the RTC)
•
Compatibility Support Module (CSM) providing legacy BIOS compati-
bility based on AMIBIOS8
•
Command shell for diagnostics and configuration
•
EFI shell commands executable from mass storage device in a Pre-OS
environment (open interface)
•
SMC support in the command shell
There are various operating systems available for the CP308. For detailed
information, please contact Kontron.
SPECIFICATIONS
Watchdog Status
Overtemperature Status
Network / Link Activity
Network Speed
Introduction
Page 1 - 13