Configuration - Raritan Dominion KX II-101-V2 User Manual

Chapter 11: Command Line Interface (CLI)
168
Command Option
verbose [on|off]
Setlog Command Example
The following Setlog command sets the logging level to debug with
verbose logging on for the libpp_serial module.
Setlog module libpp_serial level debug verbose on

Configuration

The Configuration menu enables you to access the network commands
used to configure the network interface and set the device name.
Network
The Configuration > Network commands are used to configure the KX II-
101-V2 network connection and device name.
Command
interface
name
ipv6_interface
Interface Command
The interface command is used to configure the KX II-101-V2 network
interface. When the command is accepted, the device will drop the
HTTP/HTTPS connection and initialize a new network connection. All
HTTP/HTTPS users must reconnect to the device using the new IP
address and the correct username and password. See
Configuration (on page 8).
The syntax of the interface command is:
interface [ipauto <none|dhcp>] [ip <ipaddress>]
[mask <subnetmask>] [gw <ipaddress>] [mode
<auto/10hdx/10fdx/100hdx/100fdx]
The network command options are described in the following table.
Description
Turns verbose logging on and off.
Description
Configure the KX II-101-V2 device
network interface.
Set the device name.
Set/get IPv6 network parameters.
Installation and