Raritan Dominion KX II-101-V2 User Manual page 29

Configure the KX II-101-V2 Using a Terminal Emulation Program (Optional)
You can use the Admin serial console with a terminal emulation program
like HyperTerminal to set the following configuration parameters for the
KX II-101-V2:

IP address

Subnet mask address

Gateway address

IP autoconfiguration

LAN speed

LAN interface mode
To use a terminal emulation program with the KX II-101-V2, you must
first connect the included RS-232 serial cable from the Admin port on the
KX II-101-V2 to a COM port on your PC.
For demonstration purposes, the terminal emulation program described
in this section is HyperTerminal. You can use any terminal emulation
program.
To use a terminal emulation program to configure the KX II-101-
V2:
1. Connect to the Admin port on the KX II-101-V2 and the COM1 port
on the PC.
2. Launch the terminal emulation program you want to use to configure
the KX II-101-V2.
3. Set the following port settings in the terminal emulation program:

Bits per second - 115200

Data bits - 8

Parity - None

Stop bits - 1

Flow control - None
4. Connect to the KX II-101-V2. The login page opens.
5. Type the administrator username and press Enter. You are prompted
to enter your password.
6. Type the default administrator name admin and press Enter. You are
promoted to enter your password.
7. At the Admin Port > prompt, type config and press Enter.
8. At the Config > prompt, type network and press Enter.
9. To configure new network settings, at the Network prompt, type
interface followed by one of the following commands and its
appropriate argument (option), then press Enter.
Chapter 2: Installation and Configuration
21