Configuring Event Management - Destinations; Port Configuration - Raritan Dominion KX II-101-V2 User Manual

Port Configuration

Configuring Event Management - Destinations

System events, if enabled, generate SNMP notification events (traps), or
can be logged to the syslog or audit log. Use the Event Management -
Destinations page to select the system events to track and where to
send this information.
Note: SNMP traps are generated only if the SNMP Logging Enabled
option is selected. Syslog events are generated only if the Enable Syslog
Forwarding option is selected. Both of these options are in the Event
Management - Settings page. See
Settings (on page 108).
To select events and their destinations:
1. Choose Device Settings > Event Management - Destinations. The
Event Management - Destinations page opens.
System events are categorized by Device Operation, Device
Management, Security, User Activity, and User Group Administration.
2. Select the checkboxes for those event line items you want to enable
or disable, and where you want to send the information.
Tip: Enable or disable entire Categories by checking or clearing the
Category checkboxes, respectively.
3. Click OK.
To reset to factory defaults:

Click Reset To Defaults.
WARNING: When using SNMP traps over UDP, it is possible for the
KX II-101-V2 and the router that it is attached to fall out of
synchronization when the KX II-101-V2 is rebooted, preventing the
reboot completed SNMP trap from being logged.
The Port Configuration page displays a list of the KX II-101-V2 ports.
Ports connected to KVM target servers or power strips are displayed in
blue and can be edited.
To change a port configuration:
1. Choose Device Settings > Port Configuration. The Port Configuration
page opens.
Chapter 6: Device Management
Configuring Event Management -
115