Configure The Dns Settings; Lan Interface Settings - Raritan Dominion KX II-101-V2 User Manual

Configure the DNS Settings

1. Select Obtain DNS Server Address Automatically if DHCP is
selected and Obtain DNS Server Address is enabled. When Obtain
DNS Server Address Automatically, the DNS information provided by
the DHCP server will be used.
2. If Use the Following DNS Server Addresses is selected, whether or
not DHCP is selected, the addresses entered in this section is used
to connect to the DNS server.
Enter the following information if the Following DNS Server
Addresses is selected. These addresses are the primary and
secondary DNS addresses used if the primary DNS server
connection is lost due to an outage.
a. Primary DNS Server IP Address
b. Secondary DNS Server IP Address
3. When finished, click OK.
Your KX II-101-V2 device is now network accessible.

LAN Interface Settings

The current parameter settings are identified in the Current LAN interface
parameters field.

Select the LAN Interface Speed & Duplex settings.

Autodetect (default option)

10 Mbps/Half - Yellow LED blinks

10 Mbps/Full - Yellow LED blinks

100 Mbps/Half - Yellow LED blinks and the green LED is always
lit

100 Mbps/Full - Yellow LED blinks and the green LED is always
lit
Half-duplex provides for communication in both directions, but
only one direction at a time (not simultaneously).
Full-duplex allows communication in both directions
simultaneously.
Note: Occasionally there are problems running at 10 Mbps in either
half or full duplex. If you are experiencing problems, please try
another speed and duplex.
See Network Speed Settings

Select the Bandwidth Limit.

No Limit

128 Kilobit
Chapter 6: Device Management
(on page 181).
99