Keyboard/Mouse Setup; Serial Port Settings - Raritan Dominion KX II-101-V2 User Manual

Keyboard/Mouse Setup

Serial Port Settings

Use the Keyboard/Mouse Setup page to configure the Keyboard and
Mouse interface between the KX II-101-V2 and the host device.
1. Click Device Settings > Keyboard/Mouse.
2. Select the Host Interface. This selection determines if the KX II-101-
V2 sends keyboard and mouse data through the PS/2 or USB
connections.

Auto - With this setting, the KX II-101-V2 will use a USB
connection if available, otherwise it will default to the PS/2
connection.

USB - Forces the KX II-101-V2 to use the USB connection to
send Keyboard and Mouse data to the host device.

PS/2 - Forces the KX II-101-V2 to use the PS/2 connection to
send Keyboard and Mouse data to the host device.
Note: If you are using a Raritan switch on the front-end with a KX II-
101-V2, you must set the Host Interface to PS/2 in order for the
configuration to work properly. See
123).
3. Click OK.
To reset to factory defaults:

Click Reset To Defaults.
Use the Serial Port Settings page to configure how the KX II-101-V2
employs its integrated serial port.
Chapter 6: Device Management
Analog KVM Switch (on page
105