Kx Iii Installation And Configuration; Rack Mounting - Raritan Dominion KX III Administrator's Manual

KX III Installation and Configuration

See the KX III Quick Setup Guide that came with your device or
download it from Raritan's Support website for a quick reference to the
basic, bear minimum setup steps.
Additional information and optional steps included here but not in the
QSG include:

Additional Supported Mouse Settings

LED Statuses During KX III Boot Up

Connect to a VGA Monitor (Optional)

Step 6: Configuring the Keyboard Language (Optional)
40)

Rack Mounting

The KX III can be mounted in 1U (1.75", 4.4 cm) of vertical space in a
standard 19" equipment rack.
Note: The Raritan device depicted in the rack mounting diagrams is for
example purposes only and may not depict your device. The mounting
instructions are specific to your device.
Forward Mount
The steps correspond to the numbers shown in the front rackmount
diagrams.
1. Secure the cable-support bar to the back end of the side brackets
using two of the included screws.
2. Slide the KX III between the side brackets, with its rear panel facing
the cable-support bar, until its front panel is flush with the "ears" of
the side brackets.
3. Secure the KX III to the side brackets using the remaining included
screws (three on each side).
4. Mount the entire assembly in your rack, and secure the side
brackets' ears to the rack's front rails with your own screws, bolts,
cage nuts, and so on.
5. When connecting cables to the rear panel of the KX III, drape them
over the cable-support bar.
Chapter 3: KX III Administration
(on page 22)
(on page 25)
(on page 27)
(on page
19