Step 4: Configure The Kx Ii-101-V2 - Raritan Dominion KX II-101-V2 User Manual

Step 4: Configure the KX II-101-V2

Note: You must use a crossover cable between the KX II-101-V2 and
client if you are configuring the KX II-101-V2 through a web browser.
For the following steps, you must change the default password and
assign the KX II-101-V2 its IP address at the Local Console.
All other steps can be performed from either the Local Console, or from
the KX II-101-V2 Remote Console via a supported web browser using
the KX II-101-V2's default IP address.
™
Jave 1.7 is required to use the Java-based Java-based KX II-101-V2
Virtual KVM Client and Multi-Platform Client (MPC)..
You can also use a terminal emulation program to configure the KX II-
101-V2. See Configure the KX II-101-V2 Using a Terminal Emulation
Program (Optional) (on page 21).
Change the Default Password
The first time you start the KX II-101-V2, you are required to change the
default password.
To change the default password:
1. Once the unit has booted, enter the default username admin and
password raritan. Click Login.
2. Enter the old password raritan, then enter and reenter a new
password.
Passwords can be up to 64 characters in length consisting of
English, alphanumeric and special characters.
3. Click Apply. Click OK on the Confirmation page.
Assign the KX II-101-V2 an IP Address
To assign an IP address to the KX II-101-V2:
1. Choose Device Settings > Network. The Network Settings page
opens.
2. Specify a meaningful Device Name for your KX II-101-V2 device.
Up to 32 alphanumeric and valid special characters, no spaces
between characters.
3. Next, configure the IPv4, IPv6 and DNS settings.
Chapter 2: Installation and Configuration
17