Chapter 3 Initial Installation And Configuration; Connecting Power And Equipment - Raritan PX3TS User Manual

Chapter 3

Connecting Power and Equipment

Initial Installation and Configuration
This chapter explains how to install a PX3TS device and configure it for
network connectivity.
In This Chapter
Connecting Power and Equipment............................................................ 14
Connecting the PX3TS to Your Network.................................................... 15
Configuring the PX3TS .............................................................................. 19
Bulk Configuration Methods .....................................................................27
Cascading Multiple PX3TS Devices for Sharing Ethernet Connectivity.... 28
Power-Sharing Restrictions and Connection (for iX7™ Only) .................. 38
Your PX3TS may have fuses and/or circuit breakers. Verify that all are
firmly seated or set to ON before connecting power.
The PX3TS inlets are labeled INLET 1 (I1) and INLET 2 (I2). INLET 1 is the
factory default preferred inlet, and INLET 2 is the factory default
alternate inlet.
Tip: You can switch preferred and alternate inlets if needed. See
Transfer (on page 82).
To make power connections:
1. Connect PX3TS inlets to branch circuits.
2. Connect loads to PX3TS outlets.
3. Apply power to branch circuits.
Manual
14