Raritan Dominion KX II-101-V2 User Manual page 58

Chapter 3: Working with Target Servers
50
Auto-Sense Video Settings
The Auto-sense Video Settings command forces a re-sensing of the
video settings (resolution, refresh rate) and redraws the video screen.
To automatically detect the video settings, do the following:

Choose Video > Auto-sense Video Settings, or click the Auto-Sense
Video Settings button
A message stating that the auto adjustment is in progress appears.
Adjusting Video Settings
Use the Video Settings command to manually adjust the video settings.
To change the video settings:
1. Choose Video > Video Settings to open the Video Settings dialog.
2. Adjust the following settings as required. As you adjust the settings
the effects are immediately visible:
a. PLL Settings
Clock - Controls how quickly video pixels are displayed across
the video screen. Changes made to clock settings cause the
video image to stretch or shrink horizontally. Odd number
settings are recommended. Under most circumstances this
setting should not be changed because the autodetect is usually
quite accurate.
Phase - Phase values range from 0 to 31 and will wrap around.
Stop at the phase value that produces the best video image for
the active target server.
b. Brightness: Use this setting to adjust the brightness of the target
server display.
c. Brightness Red - Controls the brightness of the target server
display for the red signal.
d. Brightness Green - Controls the brightness of the green signal.
e. Brightness Blue - Controls the brightness of the blue signal.
f. Contrast Red - Controls the red signal contrast.
g. Contrast Green - Controls the green signal.
h. Contrast Blue - Controls the blue signal.
If the video image looks extremely blurry or unfocused, the
settings for clock and phase can be adjusted until a better image
appears on the active target server.
in the toolbar.