Prop up rear of projector
1.
2.8
Install the Touch Panel Controller (TPC)
1. Loosen the mounting arm just enough for the end to fit over the ball joint located on the rear panel of the
projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the projector.
4. Adjust the angle of the TPC.
D4K35 Setup Guide
020-100855-02 Rev. 1 (09-2014)
2.
19 mm wrench
Figure 2-7 Using the Foot Extension Rods
Figure 2-8
Figure 2-9
Section 2: Installation and Setup
Remove rear feet
3.
Add foot extension rod
2-9