Installation and Setup
6. Lock the feet in place by turning each lock nut until it fits tight against the projector.
Install the Touch Panel Controller (TPC)
1. Loosen the mounting arm just enough for the end to fit over the ball joint located on the rear
panel of the projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the projector.
4. Adjust the TPC angle for optimal viewing.
14
1
2
19 mm
D4K2560/Mirage 4K25 User Manual
3
020-101076-02 Rev. 1 (11-2013)