Basic hardware procedures
4.7
Removing the HDD cage
4.7.1
Preliminary steps
Before replacing the system fan module, perform the following steps:
Ê Shut down the server as described in section
page
40.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page
43.
Ê Remove the HDDs as described in section
page
93.
I
Ensure that all cables are uniquely identified so that you can reconnect
them into their original locations after concluding the task.
Figure 20: Removing the screws from the HDD cage
Ê Remove four screws from the HDD cage (see circles).
60
"Disconnecting the power cord" on page
Upgrade and Maintenance Manual
"Shutting down the server" on
"Removing the side cover" on
"Removing 3.5-inch HDDs" on
TX100 S3 Core Edition
41.