Copying Crash Log Data Content To A Destination Device - HP Procurve 2650 Management And Configuration Manual

File Transfers
Copying Diagnostic Data to a Remote Host, PC, or Unix Workstation
At this point, press
and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-11. Example of sending a Crash Log for Slot C to a File on an Attached PC
A-18

Copying Crash Log Data Content to a Destination Device

This command uses TFTP or Xmodem to copy the Crash Log content to a PC
or UNIX workstation on the network. You can copy individual slot information
or the master switch information. If you do not specify either, the command
defaults to the master data.
Syntax: copy crash-log [<slot-id | master>] tftp <ip-address>
<filepath and filename>
copy crash-log [<slot-id | master>] xmodem
slot-id = a - h, and retrieves the crash log or crash data from
where:
master
For example, to copy the Crash Log for slot C to a file in a PC connected to
the switch:
the processor on the module in the specified slot.
Retrieves crash log or crash data from the switch's
chassis processor.