Using The Hp Toptools For Hubs & Switches Utility - HP Procurve 2650 Management And Configuration Manual

For example, to download switch software from primary flash in a Switch 2650
or 6108 with an IP address of 10.28.227.103 to the primary flash in the
destination Switch 2650 or 6108, you would execute the following command
in the destination switch's CLI:
Running Total
of Bytes
Downloaded
Figure A-5. Switch-To-Switch, from Primary in Source to Either Flash in
Destination
Downloading from Either Flash in the Source Switch to Either Flash
in the Destination Switch. This command (executed in the destination
switch) gives you the most options for downloading between switches.
copy tftp flash <ip-addr> </os/primary> | </os/secondary>
Syntax:
[primary | secondary]
If you do not specify either a primary or secondary flash location for the
destination, the download automatically goes to primary flash.
For example, to download switch software from secondary flash in a Switch
2650 or 6108 with an IP address of 10.28.227.103 to the secondary flash in the
destination switch, you would execute the following command in the destina-
tion switch's CLI:
Figure A-6. Switch-to-Switch, from Either Flash in Source to Either Flash in
Destination
Using the HP TopTools for Hubs & Switches Utility
HP TopTools for Hubs & Switches includes a software update utility for
updating on HP Procurve switch products such as the Switches 2650 and 6108.
For further information, refer to the HP TopTools for Hubs & Switches User
Guide, provided electronically with the HP TopTools software.
File Transfers
Downloading Switch Software
A-11