HP Procurve 2650 Management And Configuration Manual page 497

4. Since the OS file is large, you can increase the speed of the download by
changing the switch console and terminal emulator baud rates to a high
speed. For example:
a. Change the switch baud rate to 115,200 Bps.
b. Change the terminal emulator baud rate to match the switch speed:
i. In HyperTerminal, select
ii. Select File
iii. click on
iv. Change the baud rate to
v. Click on
vi. Select Call
vii. Press
5. Start the Console Download utility by typing
pressing :
6. You will then see this prompt:
7. At the above prompt:
y
a. Type (for Yes)
b. Select
Transfer
c. Enter the appropriate filename and path for the OS image.
d. Select the
Xmodem
e. Click on
If you are using HyperTerminal, you will see a screen similar to the
following to indicate that the download is in progress:
Call | Disconnect
| Properties .
.
115200 .
. In the next window, click on
| Connect
one or more times to display the => prompt.
| in HyperTerminal.
File
protocol (and not the 1k Xmodem protocol).
.
Troubleshooting
Restoring a Flash Image
.
again.
at the prompt and
do
C-35