HP Procurve 2650 Management And Configuration Manual page 384

Hide thumbs Also See for Procurve 2650:
Table of Contents

Advertisement

HP Procurve Stack Management
Configuring Stack Management
In this stack, the only SNs in use are 0 and 1,
so you can use any SN number from 2 through
15 for new Members. (The SN of "0" is always
reserved for the stack Commander.)
Figure 14-28. Example of How To Determine Available Switch Numbers (SNs)
MAC addresses
of discovered
Candidates.
Figure 14-29. Example of How To Determine MAC Addresses of Discovered Candidates
14-36
Using the Commander's CLI To Manually Add a Candidate to the
Stack. To manually add a candidate, you will use:
I
A switch number (SN) to assign to the new member. Member SNs range
from 1 to 15. To see which SNs are already assigned to Members, use show
stack view. You can use any SN not included in the listing. (SNs are
viewable only on a Commander switch.)
The MAC address of the discovered Candidate you are adding to the stack.
I
To see this data, use the show stack candidates listing.
For example:
To display all discovered Candidates with their MAC addresses, execute show
stack candidates from the Commander's CLI. For example, to list the discov-
ered candidates for the above Commander:
Knowing the available switch numbers (SNs) and Candidate MAC addresses,
you can proceed to manually assign a Candidate to be a Member of the stack:
Syntax: stack member <switch-number> mac-address <mac-addr>
[password <password-str>]
Note: When manually adding a switch, you must assign an SN.
However, if the Commander automatically adds a new Member,
it assigns an SN from the available pool of unused SNs.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 6108

Table of Contents