Operating Notes - HP Procurve 2650 Management And Configuration Manual

Configuring for Network Management Applications
CDP
CDP MIB data is
grouped by type.
That is, the
Address Types
for all detected
CDP devices are
listed first, then
the IP
addresses of the
source devices,
and so on.
Figure 10-16. Example of CDP Neighbor Data in a Switch 2650 or 6108MIB
10-28
For the current Switch 2650 or 6108 MIB, go to the HP Procurve World Wide
Web site at:
http://ww.hp.com/go/hpprocurve
Click on software, then MIBs.

Operating Notes

Neighbor Maximum. The Switches 2650 and 6108 support up to 60 entries
(neighbors) in the CDP Neighbors table. Remember that multiple CDP devices
can be neighbors on the same port if they are connected to the switch through
a non-CDP device.
CDP Version Data. The Switches 2650 and 6108 use CDP-V1, but do not
include IP prefix information, which is a router function; not a switch appli-
cation.
Port Trunking with CDP. Where a static or LACP trunk forms the link
between the switch and another CDP device, only one physical link in the
trunk is used to transmit outbound CDP packets.
The first number after the MIB string is the switch port on
which the data point for that entry was received. In this
case, the switch CDP packets on ports A1 and A3. (For CDP
purposes, port numbering is consecutive, from 1 to n,
where n is the last consecutive port on the switch.)