HP Procurve 2650 Management And Configuration Manual page 316

802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
Configuring Rapid Reconfiguration Spanning Tree (RSTP)
Spanning Tree Commands in This Section
show spanning-tree config
spanning-tree
protocol-version <rstp | stp>
force-version <rstp-operation | stp-compatible>
forward-delay <4 - 30>
hello-time <1 - 10>
maximum-age <6 - 40>
priority <0 - 15 | 0 - 65535>
<[ethernet] port-list>
path-cost <1 - 200 000 000>
priority <0 - 15 | 0 - 65535>
edge-port
point-to-point-mac
mcheck
mode <norm | fast>
show spanning-tree
13-10
CLI: Configuring RSTP
Viewing the Current Spanning Tree Configuration. Even if spanning
tree is disabled (the default configuration), the show spanning-tree config
command lists the switch's full spanning tree configuration, including whole-
switch and per-port settings.
show spanning-tree configuration
Syntax:
Abbreviation:
In the default configuration, the output from this command appears similar to
the following:
Applicable Location
Protocol
Version
both Below on this page
both page 13-11
both page 13-12
RSTP page 13-12
both page 13-12
both page 13-12
both page 13-12
RSTP | STP page 13-12
both page 13-14
both page 13-14
RSTP | STP page 13-14
RSTP page 13-14
RSTP page 13-14
RSTP page 13-14
STP Refer to "802.1p Spanning-Tree Protocol (STP)"
on page 13-19.
This command lists additional RSTP/STP monitoring data that is
not covered in this section. See "Spanning Tree Protocol
Information" in Chapter B, "Monitoring and Analyzing Switch
Operation"
sho span config