HP Procurve 2650 Management And Configuration Manual page 115

Figure 6-3. Example of Executing the Console Command with Multiple Parameters
Configure
the
individual
parameters.
Save the
changes.
Boot the
switch.
Figure 6-4. Example of Executing a Series of Console Commands
VT100 operation
I
I 19,200 baud
No flow control
I
10-minute inactivity time
I
I Critical log events
you would use the following command sequence:
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
You can also execute a series of console commands and then save the
configuration and boot the switch. For example:
Interface Access, System Information, and Friendly Port Names
Interface Access: Console/Serial Link, Web, and Inbound Telnet
write memory reload
and .
6-7