Reinstalling System Fans, Pci Card Cage, Airflow Guides, Memory, And The Management Processor; Figure 1-44 Connecting The Power Pod Cable - HP Integrity rx2600 Upgrade Manual

HP Integrity rx2620 Upgrade
System Hardware Component Upgrade Instructions

Figure 1-44 Connecting the Power Pod Cable

Reinstalling System Fans, PCI Card Cage, Airflow Guides, Memory, and the
Management Processor
Reinstall the Management Processor
NOTE Connect SCSI cables before replacing the Management Processor.
Step 1. Insert the management processor in the system.
Step 2. Grasp its edges and place it on the two management processor posts.
Step 3. Push the 10/100 management LAN, 15-pin VGA and 25-pin serial connectors through their
openings on the back of the system
Step 4. Connect the management processor:
• Connect the management processor cable to its connector on the system board.
• Screw in the two mounting screws that connect the management processor to the internal
chassis post.
• Screw in the two external mounting screws that are located on both sides of the 25-pin serial
connector.
Step 5. Replace the power connectors in their slots on the back of the system and screw in the power
connector mounting screws.
50
Front of Chassis
Chapter 1