Removing A Hard Disk Drive From The Optical Drive Bay - HP Z800 Workstation Maintenance And Service Manual

Hide thumbs Also See for Z800 Workstation:
Table of Contents

Advertisement

Removing a hard disk drive from the optical drive bay

1.
2.
3.
4.
5.
6.
122 Chapter 5 Replacing components
Downloaded from
www.Manualslib.com
Disconnect power from the workstation (see
Remove the side access panel (see
Remove the airflow guide (see
Remove the expansion card support (see
Disconnect the power and data cables from the rear of the hard drive as shown in the following
figure.
Figure 5-59
Removing the power and data cables
Lift the drive release latch at the green touch point
chassis as shown in the following figure
Figure 5-60
Removing the drive from the ODD bay
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
Removing the expansion card support on page
, and then slide the hard drive carrier from the
.
2
76).
78).
79).
80).
ENWW

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents