Removing A Hard Disk Drive From The Optical Drive Bay - HP Z600 Maintenance And Service Manual

Removing a hard disk drive from the optical drive bay

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Disconnect the power
following figure.
Figure 5-54
4. Lift the drive release latch at the green touch point
from the chassis as shown in the following figure
Figure 5-55
ENWW
and data
2
Removing the power and data cables
Removing the drive from the ODD bay
Predisassembly procedures on page
Removing the side access panel on page
cables from the rear of the hard disk drive as shown in the
, and then slide the hard disk drive carrier
.
2
Removing and installing components 113
73).
75).