Chapter 4: Installing Components
7
From the back of the server, press the card's locking clip in until it clicks
into place.
8
Reinstall the top rear panel.
Replacing a standard expansion card
The server must be off when you install expansion cards into PCI card slots
1 through 4.
Warning
To replace an expansion card:
1
Follow the instructions in
page
cords and all other cables connected to the server.
2
Remove the inside panel. For instructions, see
on page
3
Disconnect any cables attached to the card.
4
Press down on the expansion card's locking clip, then rotate the clip up
and out of the way.
84
Standard expansion cards cannot be replaced while the
server is on.
36. Make sure that you turn off the server, then unplug the power
45.
www.gateway.com
"Preventing static electricity discharge" on
"Removing the inside panel"