Adding A Redundant Power Supply - Gateway 995 User Manual

Adding a redundant power supply

To add a third (redundant) power supply:
1
Remove the front cover, if installed. For instructions, see
cover" on page
2
Remove the screw that secures the redundant slot's cover to the server, then
remove the slot cover.
Screw
3
Insert the new power supply into the vacant slot, then press it all the way
in until it clicks into place.
4
If you have added a third power supply to the server for the first time,
you must run the FRU/SDR utility for the server to use it as a redundant
power supply. For instructions on running the FRU/SDR utility, see
the FRU/SDR Load utility" on page
39.
www.gateway.com
Installing power supply components
26.
"Using the front
"Using
51